Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Proximity Sensor push-up counter does not stop counting #61642
    avatarBramscho
    Participant

    I guess I spoke just too soon, I am not sure exactly what I did but now it is working. When the Arduino starts up even without activating the sensor 1 pushup is recorded, then you have to wait about 7 seconds because the sensor does not record anything, and then it will start counting 1-5 1 per pushup and then displaying the message when done. So it is working now with a few odd tweaks to still smooth out.
    thanks,
    Bram

    in reply to: Proximity Sensor push-up counter does not stop counting #61640
    avatarBramscho
    Participant

    I do not know if there is a problem with my OneSheeld or what but it is still just counting from 1-5 displaying that message, waiting a few seconds, and then doing it again using the exact code you just sent. I don’t know what the problem is but it is very frustrating and I appreciate your continual support.
    Thanks
    Bram

    in reply to: Proximity Sensor push-up counter does not stop counting #61274
    avatarBramscho
    Participant

    I tried that and now it runs on its own – I do not even have to trigger the proximity sensor it counts 1-5 then says pushups done, waits a little, then does it again.

    in reply to: Proximity Sensor push-up counter does not stop counting #60994
    avatarBramscho
    Participant

    Hello,
    I tried using your code but when I tried all it would do when I put my hand of the proximity sensor for the first time is it would count: 1, 2, 3, 4, 5 and then “Pushups Done”. I tried various versions using your code as a base and it still does not work. Any other ideas?
    Thanks a bunch,
    Bram

    in reply to: Phone/SMS/Skype shields for iPhones #28315
    avatarBramscho
    Participant

    That’s because they are only available for Android – I use Bluestack emulator on my mac

Viewing 5 posts - 1 through 5 (of 5 total)